2T Reverse Osmosis in Water Treatment
The device’s key part is reverse osmosis membranes that is from the America, it has a good performance to eliminate salts and the high pressure pump is from a high quality pump producer in China, it’s easy to handle for its simple structure. The source water, in the case that the conductivity is less than 500us/CM, can reach the national standards totally after treatment by this device, it’s the most ideal equipment for water treatment.
2.Silica sand filter
3.Active carbon filter
4. Sodium ion exchanger
5. Precision filter
7.RO buffer tank
9.Ozone mixing tower
Water filter system with atural rubber inside
Water treatment plant
Place of Origin
Jiangsu, China (Mainland)
SS304 / SS316
0.5-100 ton/hour or customized
Online of RO
TDS and PH Meter
Total disolved solids
Suitable raw water
River, underground water, mountain water
t is that is 5reverse osmosis selected Dow aromatic polyamide membrane BW30- and supporting material ofglassfiber reinforced plastic pressure vessels dedicated RO membrane element , sub- installed in pressurevessel, the installation water production 0.0m3 / h , water recovery rate 70%, desalinationrate 97%
High-pressure pumpprovide power touse DLF60430335
RO protect system: set up pressure switch on inlet and outlet of the high-pressure pump.
When the pressure of the inlet is lower then the limit value (water scarcity≤0.05Mpa) or the
pressure of the outlet is higher than limit value(P≥1.8Mpa),the pressure switch send signals
to the control system and alarm, high-pressure pump stop running automatically, to ensure
the safety of the RO system. The high-pressure pump is equipped with valve; the reverse
osmosis membrane can lift pressure slowly, to avoid the damage of high-pressure water
impact. RO concentrated water end set electrically operated valve, used when low-pressure
rinsing. There will be auto low-pressure rinsing 10-20min when RO system stops running, to
avoid deposition and fouling on the membrane surface.
Regular low-pressure large flow auto cleaning of reverse osmosis system
Display :RO water product quantity display online
System control: The system use centralized control method (auto and manual two
statuses).There is a process control box, operation status is clear. Each tank’s liquid level
Silica sand filter
It can remove the suspended solids and gluten particles in the water, thus reduce the turbidity of water.
Active carbon filter
It can remove the pigment, smell and a large number of biological organisms in the water
Soften the water.
Sodium ion exchanger
It can remove calcium and magnesium ions in the water, so as to soften the water.Water filter tank-Use natural rubber inside,it will protect the stainless steel from silica sand and carbon material,make the filters work much much longer than normal.
It can ensure that the granularity of the water into reverse osmosis membrane is less than 0.1um.
It uses the UV to kill some bacteria that may also pass through the reverse osmosis system.
Disinfect tube adopt high -quality stainless steel , the material with high efficiency which can get rusty reflection have to ultraviolet ray, will not produce pollution while using , accord with the hygienic requirements of food industry. Tube built-in ultraviolet lamp and quartz glass tube, disinfect tube for airtight container
Some bacteria may not be killed by UV, the sterilizer uses ozone to kill those bacteria.We use stainless steel 316 for ozone tower,as it can resist Ozone very well than SS304,the working life will be much longer.
1.Technology corona discharge quartz ozone cell
2.Adjustable Ozone output
3.Cooling way: advanced water-cooling
4. Inner air compressor and refrigerant dryer
5. Inner PSA oxygen generator unit
<img src="/Content/ue/net/upload/2017-02-28/6dc5232f-ad76-4e58-b810-6a17f462c16f.png" alt="" width: 600px; height: 403px;" width="600" height="403"/>